Building a Greenhouse Roof (North half) (Greenhouse Build #4)

Building a Greenhouse Roof (North half) (Greenhouse Build #4)


all that paneling up there used to be on
my front porch before I did my roof project and tore it down and replaced it
that’s all reclaimed recycled roofing there I basically had to take a 2×4
strip it in half do a rip cut on it to fill this gap so it would sit well
kind of flush and so it wouldn’t be but wobbling back and forth
give it some rigidity okay so the way this goes together
basically the reason why I’m picking the stuff up on its side and then dropping
it back down because it’s kind of got a tongue and groove thing going on here where
you have to tilt it on its side in order for this piece to bite onto this
piece and then once you put it down then it locks into place I put this piece here placement wise
because of these holes back up in here that were they were just there from the
previous installation on the house so I figured what I’d end up doing is I can
get some longer screws and I’ll just use these same holes to attach it to here
anyway that was my thinking when I did this until I get these screws in there
is a screw right here fastening this top ok so what I did here was I left a gap
obviously and the idea is I’m gonna come back and I’m gonna put some rain gutters
up here

9 thoughts on “Building a Greenhouse Roof (North half) (Greenhouse Build #4)

Leave a Reply

Leave a Reply

Your email address will not be published. Required fields are marked *